Service Announcement: Please note that there are possible Auspost shipping delays in some states and territories.
Airwrap

Cot Liner Fitting Instructions

  • Place inside cot/crib/cotbed with grip tape facing the slats.
  • Loop end around single slat only, to ensure maximum grip tape contact.
  • Fasten top and bottom grip tape evenly to ensure a firm fit.
  • Pull and do the same at the other end.
  • Ensure cot liner is even on both sides.
  • Tighten by readjusting either end until cot liner is fitted firmly and securely.

    Repeat for all remaining sides

  • The bottom edge of the cot liner should sit just under the surface level of the mattress.
  • Be sure not to fit too tight otherwise cot liner could be used as leverage once your child can stand.

2 x LONG PIECES

The 2 x long pieces are for the long sides of the cot. If fitted correctly cot liner should look as above. 

2 x SHORT PIECES

The 2 x short pieces are for the top and end of the cot. If fitted correctly cot liner should look as above.

Fitting Alternatives

Airwrap can be fitted to many different types crib/cot/cot beds. 

STANDARD
COT/ CRIB/ COTBED

slatted on all sides

Want to shop Cot Liners for this kind of bed?

Shop Now
SOLID SIDE
COT/ CRIB/ COTBED  

slatted on both ends
and one side

Want to shop Cot Liners for this kind of bed?

Shop Now
SOLID TOP
COT/ CRIB/ COTBED 

slatted on both sides
and one end

Want to shop Cot Liners for this kind of bed?

Shop Now
SOLID TOP & END
COT/ CRIB/ COTBED

slatted on both sides

Want to shop Cot Liners for this kind of bed?

Shop Now
BACK TO TOP